Back to Contents Page

Using Your Adjustable Monitor Stand

Dell™ 2405FPW Flat Panel Monitor

  Attaching the Stand

  Organizing Your Cables

  Using the Tilt, Swivel, Vertical Extension

  Removing the Stand 

Attaching the Stand

1. Place the stand on a flat surface.
2. Fit the groove on the back of the monitor onto the three teeth of upper stand.
3. Lower the monitor so that the monitor mounting area snaps on/locks to stand.
    

Organizing Your Cables

 

After attaching all necessary cables to your monitor and computer, (See Connecting Your Monitor for cable attachment,) use the cable holder to neatly organize all cables as shown above.

Using the Tilt, Swivel and Vertical Extension

Tilt/Swivel

With the built-in pedestal, you can tilt and/or swivel the monitor for the most comfortable viewing angle.

NOTE: Stand is detached and extended when the monitor is shipped from the factory.

Vertical Extension

Stand extends vertically up to 100mm via the stand lock release button.

NOTE: If locked in the down position, press the stand lock release button on the bottom rear of stand. Lift the front panel up and extend the stand to the desired height.

NOTICE: Before relocating/moving the monitor to a different location, make sure that the stand is LOCKED DOWN. To lock it down, lower the height of the panel until it clicks and is locked into place.

Removing the Stand

 After placing the monitor panel on a soft cloth or cushion, press and hold the LCD removal button, and then remove the stand.

NOTE: To prevent scratches on the LCD screen while removing the stand,  ensure that the monitor is placed on a clean surface.

Back to Contents Page