Manuals

Manuals
Center Control Cover: Dell Studio 1535/1536 Service Manual

Back to Contents Page

Center Control Cover

Dell™ Studio 1535/1536 Service Manual


CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on the back of the computer).
NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the computer.

Removing the Center Control Cover

  1. Follow the procedures in Before You Begin.

  2. Remove the two screws securing the center control cover from the battery bay.

  1. Turn the computer over and open the display as far as possible.

  2. Pry out the center control cover with your fingers starting from the battery bay location at the back of the system.

NOTICE: To avoid damage to the data cable connected to the system board, ensure that you do not pull hard when you are lifting the center control cover.
  1. Ease the center control cover up.

1

center control cover

  1. Remove the keyboard surround by easing it out using a scribe (see Removing the Keyboard).

  2. Remove the two screws from the top of the keyboard.

NOTICE: The key caps on the keyboard are fragile, easily dislodged, and time-consuming to replace. Be careful when removing and handling the keyboard.
  1. Lift the keyboard and hold it up and slightly forward to access the media control buttons connector on the system board.

1

media control buttons cable

2

media control buttons connector

  1. Disconnect the media control buttons cable from the connector on the system board.

Replacing the Center Control Cover

  1. Follow the procedures in Before You Begin.

  2. Reconnect the media control buttons cable to the connector below the keyboard on the system board.

  3. Align the tabs along the bottom of the keyboard and slide them under the palm rest.

  4. Replace the keyboard surround.

  5. Press on the corner edges near the top to snap the keyboard into place.

  6. Replace the two screws on the top of the keyboard.

  7. Slide the center control cover into the keyboard surround and press at both the edges of the cover until it snaps into place.

  8. In the battery bay, replace the two screws that secure the center control cover.

Back to Contents Page

 

Copyright 1999-2012 Dell Inc. | Terms and Conditions |  Unresolved Issues | Privacy Statement | About Our Ads | Contact | | Feedback

Large Text
©2009 Dell Corporation Limited Dell, the Dell logo, Dell Precision are registered trademarks or trademarks of Dell Inc. Celeron, Celeron Inside, Centrino, Centrino Inside, Core Inside, Intel, Intel Logo, Intel Atom, Intel Atom Inside, Intel Core, Intel Inside, Intel Inside Logo, Intel Viiv, Intel vPro, Itanium, Itanium Inside, Pentium, Pentium Inside, Viiv Inside, vPro Inside, Xeon, and Xeon Inside are trademarks of Intel Corporation in the U.S. and other countries. Microsoft, MS and Windows are registered trade marks of Microsoft Corporation. Other trade marks or trade names may be used in this document to refer to either the entities claiming the marks and names of their products. Dell disclaims proprietary interest in the marks and names of others. Dell Corporation Limited, Dell House, The Boulevard, Cain Road, Bracknell, Berkshire, RG12 1LF.


snWEB5