Back to Contents Page

Back I/O Panel

Dell Studio One 19/1909 Service Manual

  Removing the Back I/O Panel

  Replacing the Back I/O Panel

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

Removing the Back I/O Panel

1. Follow the procedures in Before You Begin.
   
   
2. Remove the computer cover (see Removing the Computer Cover).
   
   
3. Remove the shield (see Removing the Shield).
   
   
4. Remove the stand (see Removing the Stand).
   
   
5. Remove the two screws that secure the back I/O panel to the system board.
   
   
6. Lift the back I/O panel away from the system board.
   
   
   
   

1

screws (2)

2

back I/O panel connector

Replacing the Back I/O Panel

1. Follow the procedures in Before You Begin.
   
   
2. Slide the back I/O panel into the connector (PCIE_4X_1) on the system board until it is securely in place.
   
   
3. Replace the two screws that secure the back I/O panel to the system board.
   
   
4. Replace the stand (see Replacing the Stand).
   
   
5. Replace the shield (see Replacing the Shield).
   
   
6. Replace the computer cover (see Replacing the Computer Cover).
   
   
7. Connect your computer and all attached devices to electrical outlets, and turn them on.
   
   

Back to Contents Page