Back to Contents Page

Speakers

Dell Studio One 19/1909 Service Manual

  Removing the Right Speaker

  Replacing the Right Speaker

  Removing the Left Speaker

  Replacing the Left Speaker

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

Removing the Right Speaker

NOTE: To locate the right speaker, see Inside View of Your Studio One.

1. Follow the procedures in Before You Begin.
   
   
2. Remove the computer cover (see Removing the Computer Cover).
   
   
3. Remove the shield (see Removing the Shield).
   
   
4. Remove the stand (see Removing the Stand).
   
   
5. Remove the processor fan and heat sink (see Removing the Heat Sink and Removing the Processor Fan).
   
   
6. Remove the four screws that secure the speaker to the chassis.
   
   

NOTE: Make a note of the cable routing before you dislodge the cable.

7. Disconnect the right speaker cable from the connector (SPEAKER_2) on the system board.
   
   
   
   

1

screws (4)

2

speaker cable

8. Lift the speaker away from the chassis.
   
   

Replacing the Right Speaker

1. Follow the procedures in Before You Begin.
   
   
2. To replace the speaker, route the speaker cables back into position.
   
   
3. Connect the right speaker cable to the connector (SPEAKER_2) on the system board.
   
   
4. Place the speaker in position and replace the four screws that secure the speaker to the chassis.
   
   
5. Replace the processor fan and heat sink (see Replacing the Heat Sink and Replacing the Processor Fan).
   
   
6. Replace the stand (see Replacing the Stand).
   
   
7. Replace the shield (see Replacing the Shield).
   
   
8. Replace the computer cover (see Replacing the Computer Cover).
   
   
9. Connect your computer and all attached devices to electrical outlets, and turn them on.
   
   

Removing the Left Speaker

NOTE: To locate the left speaker, see Inside View of Your Studio One.

1. Follow the procedures in Before You Begin.
   
   
2. Remove the computer cover (see Removing the Computer Cover).
   
   
3. Remove the shield (see Removing the Shield).
   
   
4. Remove the four screws that secure the speaker to the chassis.
   
   

NOTE: Make a note of the cable routing before you dislodge the cable.

5. Disconnect the left speaker cable from the connector (SPEAKER_1) on the system board.
   
   
   
   

1

screws (4)

2

speaker cable

6. Lift the speaker away from the system board.
   
   

Replacing the Left Speaker

1. Follow the procedures in Before You Begin.
   
   
2. To replace the speaker, route the cables back into position.
   
   
3. Reconnect the left speaker cable to the connector (SPEAKER_1) on the system board.
   
   
4. Replace the four screws that secure the speaker to the chassis.
   
   
5. Replace the shield (see Replacing the Shield).
   
   
6. Replace the computer cover (see Replacing the Computer Cover).
   
   

Back to Contents Page