Back to Contents Page

Wireless Switch Assembly

Dell™ Inspiron™ 1318 Service Manual

  Removing the Wireless Switch Assembly

  Replacing the Wireless Switch Assembly

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions shipped with your computer.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer.

NOTICE: Handle components and cards by their edges, and avoid touching pins and contacts.

Removing the Wireless Switch Assembly

1. Follow the instructions in Before You Begin.
   
   
2. Remove the system board (see System Board).
   
   
3. Remove the two M2 x 3-mm screws from either side of the wireless switch assembly board and lift it away from the computer base.
   
   

1

M2 x3-mm screws (2)

2

wireless switch assembly board

3

wireless switch assembly cable connector

Replacing the Wireless Switch Assembly

1. Secure the wireless switch assembly board to the computer base by replacing the two M2 x 3-mm screws.
   
   
2. Replace the system board (see System Board).
   
   
3. Slide the battery into the battery bay, until it clicks into place.
   
   

Back to Contents Page