CAUTION: If you remove the hard drive from the computer when the drive is hot, do not touch the metal
housing of the hard drive.
CAUTION: Before you perform the following procedures, see the safety instructions in the Product
Information Guide.
NOTICE: To avoid damaging the system board, you must remove the main battery before you begin
working inside the computer.
NOTICE: To prevent data loss, turn off your computer before removing the hard drive. Do not remove the
hard drive while the computer is on, in standby mode, or in hibernate mode.
NOTICE: Hard drives are extremely fragile; even a slight bump can damage the drive.
Dell does not guarantee compatibility or provide support for hard drives from sources other than Dell.
Turn the computer over and remove the two M3 x 3-mm screws.
1
M3 x 3-mm screws (2)
2
hard drive
NOTICE: When the hard drive is not in the computer, store it in protective antistatic packaging. See
"Protecting Against Electrostatic Discharge" in your Product Information Guide.
Slide the hard drive out of the computer.
Replacing the Hard Drive
NOTICE: Use firm and even pressure to slide the drive into place. If you use excessive force, you may
damage the connector.
Slide the drive into the bay until it is fully seated.
Replace and tighten the screws.
If the new hard drive is not already pre-imaged, install the operating system and device drivers
for your computer.
Returning a Hard Drive to Dell
NOTE: The old hard drive should be inserted in the replacement drive's anti-static bag before packing in
foam.
Return your old hard drive to Dell in its original or comparable foam packaging. Otherwise, the hard drive may be damaged in transit.
