CAUTION: Before performing the following procedures, read the safety instructions in your System Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or
by periodically touching an unpainted metal surface (such as the back panel) on the computer.
NOTICE: You must remove the display assembly before you remove the palm rest.
Disconnect the display cable using the pull-tab, and release the cable from the four
cable-routing clips.
NOTE: When you replace the display assembly, ensure that you route the display cable under
the EMI clip and cable-routing clips.
Lift the display out of the computer.
1
display
2
display cable connector
3
computer base
4
pull-tab
5
connector
1
M2.5 shoulder screws (2)
4911U
4
M2 x 6-mm screws (6)
4911U
2
Screw covers (2)
4W401
5
display bezel
8T884
3
display bumpers (6)
6W052
6
M2 x 3-mm screws (9)
Display Bezel
CAUTION: Before performing the following procedures, read the safety instructions in your System Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or
by periodically touching an unpainted metal surface (such as the back panel) on the computer.
Use a plastic scribe to pry the eight display bumpers out of the screw holes located on
the front of the bezel.
Remove the eight M2.5 x 6-mm screws located on the front of the bezel.
NOTICE: Carefully separate the bezel from the top cover to avoid damage to the bezel.
Starting at the bottom of the display panel (by the DELL™ logo), use your fingers to
separate the bezel from the top cover by lifting the inside edge of the bezel away from
the top cover.
Display Panel
CAUTION: Before performing the following procedures, read the safety instructions in your System Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or
by touching an unpainted metal surface on the computer.
