Hinge Cover

Dell™ Latitude™ XT2 Service Manual

  Removing the Hinge Cover

  Replacing the Hinge Cover

WARNING: Before working inside your Tablet-PC, read the safety information that shipped with your Tablet-PC. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of the computer.

CAUTION: The hinge cover is fragile and can be damaged if extreme force is used. Be careful when removing the hinge cover.

Removing the Hinge Cover

1. Follow the procedures in Before Working Inside Your Tablet-PC.
2. Turn the computer top-side up, and then open the display all the way (180 degrees) so that it rests on your work surface.

3. Insert a plastic scribe or flathead screwdriver into the slot and gently pry up the hinge cover on the right side to release.

4. Ease the hinge cover up, moving from right to left, and remove it.

Replacing the Hinge Cover

To replace the hinge cover, insert the left edge of the cover into the hinge cover slot and press from left to right until the cover snaps into place.