Back to Contents Page

Power Button Board

Dell™ Inspiron™ 910 Service Manual

  Removing the Power Button Board

  Replacing the Power Button Board

CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on the back of the computer).

Removing the Power Button Board

1. Follow the instructions in Before You Begin.
   
   
2. Remove the module cover (see Removing the Module Cover).
   
   
3. Remove the keyboard (see Removing the Keyboard).
   
   
4. Remove the palm rest (see Removing the Palm Rest).
   
   
5. Turn the palm rest over.
   
   

1	screw (2)	2	power button board
3	power button cable

6. Remove the two screws that secure the power button board to the palm rest.
   
   
7. Lift the power button board off the palm rest.
   
   

Replacing the Power Button Board

1. Insert the power button board into the slot and tighten the two screws.
   
   
2. Turn the palm rest over.
   
   
3. Replace the palm rest (see Replacing the Palm Rest).
   
   
4. Replace the keyboard (see Replacing the Keyboard).
   
   
5. Replace the module cover (see Replacing the Module Cover).
   
   
6. Slide the battery into the battery bay, until it clicks in place and slide the battery-lock latch towards the lock position.
   
   

Back to Contents Page